D30 sleeve & C gussets

[MRGC]

Anyone know someone in Sydney that can do the welding for the C gussets and to check the housing is nice and straight?

[Nekked]

Shents Automotive in the central coast i believe can do it??? but dont quote me on that.

[MRGC]

Any closer to sydney

[AV8]

Overkill Engineering Hornsby. Facebook.

[reyzor]

shents would be my first pick..... its only 40 mins up the freeway.......

[stevet]

You could ask John at J-mac diff & gears in Arndell Park. He has built a lot of the comp rigs for tuff truck etc.

[MRGC]

Any from the above done this job before?

[Wooders]

Any of those should be able to do it. Done a few myself and they are fairly straight forward.

Sent from my GT-N7105T using Tapatalk

[MRGC]

Any of those should be able to do it. Done a few myself and they are fairly straight forward.

Sent from my GT-N7105T using Tapatalk

Can you do mine, I want to make the housing is straight before adding the sleeves and gussets.

[Wooders]

Yes I can.
Its extremely unlikely that the centre (cast section) is bent, its usually the tubes, and the sleeves are usually a snug fit inside. So you'd know pretty quick if theres a bend ;)
But yes checking is usually part of the process. With external trusses I usually check afterwards too so to ensure the welding hasn't wrapped the housing. But this isn't an issue with sleeves.

Sent from my GT-N7105T using Tapatalk

[Wolfe]

Overkill Engineering Hornsby. Facebook.
In my opinion it would be unwise to deal with this company. From my personal experience it would not be in your best interest to do so.

[Wolfe]

I'm not making unsubstantiated claims . i have court documents to back it all up. From my experience I would be hesitant to use their services. If you decide to do so its up to you. Just do some research online or ask around before using any service provider.

[MRGC]

I'm not making unsubstantiated claims . i have court documents to back it all up. From my experience I would be hesitant to use their services. If you decide to do so its up to you. Just do some research online or ask around before using any service provider.

Thanx for the heads up, I'll stay away from them.

[MRGC]

Yes I can.
Its extremely unlikely that the centre (cast section) is bent, its usually the tubes, and the sleeves are usually a snug fit inside. So you'd know pretty quick if theres a bend ;)
But yes checking is usually part of the process. With external trusses I usually check afterwards too so to ensure the welding hasn't wrapped the housing. But this isn't an issue with sleeves.

Sent from my GT-N7105T using Tapatalk

Sent a PM.

[Wolfe]

Sent a PM.
You may need to be patient as Dave is getting every thing sorted after his move.

[MRGC]

You may need to be patient as Dave is getting every thing sorted after his move.

No probs, I'm not in a hurry.