Code Reader

[Hunno]

Anyone in the rouse Hill Vineyard area have a code readerI can borrow just to read the fault code. Pretty sure it the TPS again but just want make sure

[sbadman]

Can you do a key on-key off sequence? That's how I check codes on my pre-OBD-II XJ...

[85cj7]

Not sure if this applies to you but if your vehicle is 1995 or earlier (OBD I) then you can use a section of 16 gauge wire and a 12 volt test light and get a flash result code reading, then look up the flash code sequence on the internet. For Chrysler vehicles it is the easiest, just turn the ignition key on and off and wait 5 seconds and the codes will begin to flash on the dash panel. Hope this helps.